Reinforced Brake Disc 160 mm with 6 Holes for Rovoron S7

Reinforced Brake Disc 160 mm with 6 Holes for Rovoron S7

This is a model-specific replacement brake disc designed for the Rovoron S7 electric scooter. It features a 160 mm diameter and a 6-hole mounting pattern. The reinforced design is intended to provide stable braking performance, particularly under higher loads or during frequent braking.

This brake disc is suitable for replacing worn, warped, or damaged discs on your Rovoron S7. It is an essential component of the braking system, and its proper function is critical for safe operation.

Key Characteristics

• Diameter: 160 mm
• Mounting: 6-hole pattern (inner bolt circle diameter 50 mm, center bore 25 mm)
• Type: Reinforced brake disc
• Compatibility: Specifically for Rovoron S7 electric scooters
• Weight: Approximately 123g
• SKU: ULP5118.00
• Package Contents: 1 brake disc (mounting screws are included as per image evidence)

When to Replace Your Brake Disc

Consider replacing your brake disc if you experience any of the following:

• Pulsation, grinding, or rubbing sensations during braking.
• Visible damage to the braking surface, such as deep grooves, cracks, or excessive scoring.
• Signs of overheating, such as discoloration or blue spots on the disc.
• The disc appears warped or bent, which can be identified by uneven pad wear or a wobbling disc.
• The disc thickness is below the manufacturer's recommended minimum limit (check your scooter's manual for specific values).
• Damage to the mounting points or noticeable play in the disc.

Before Ordering and Installation

To ensure correct fitment, it is crucial to verify the specifications of your existing brake disc against this product. While this disc is specified for the Rovoron S7, variations can occur between production batches or specific models. Please compare the following:

• Outer Diameter: Confirm it is 160 mm.
• Mounting Hole Pattern: Count the holes (this disc has 6) and measure the inner bolt circle diameter (50 mm) and center bore (25 mm) to ensure it matches your hub.
• Disc Thickness: While not explicitly stated, ensure the thickness is compatible with your caliper.

Installation of brake components should ideally be performed by a qualified service technician. Incorrect installation can compromise braking performance and safety. Ensure that mounting screws are tightened evenly and to the manufacturer's specified torque values (refer to your scooter's service manual). After installation, the brake caliper must be accurately centered over the new disc.

It is also recommended to inspect your brake pads when replacing the disc. Worn, contaminated, or incompatible pads can quickly damage a new brake disc. Always replace pads if they are heavily worn or show signs of oil/grease contamination.

Bedding-In Procedure

After installing a new brake disc, a proper bedding-in procedure is essential for optimal performance and longevity. This involves a series of gradual braking actions to allow the brake pads and disc surfaces to conform to each other. Avoid hard, sudden braking immediately after installation. Instead, perform several moderate stops from increasing speeds, allowing the brakes to cool between each stop. This process helps to transfer an even layer of pad material onto the disc, improving braking efficiency and reducing noise.