ULIP HP1007B 10×2.75-6.5 off-road tubeless tire for Ausom L2 Max Dual Motor

ULIP HP1007B 10×2.75-6.5 off-road tubeless tire for Ausom L2 Max Dual Motor

The ULIP HP1007B tubeless tire for Ausom L2 Max Dual Motor has closely spaced tread blocks along the centre and angled shoulder blocks. The channels between them form a tread for mixed surfaces. The tire is marked 10×2.75-6.5 and is intended for a suitable 6.5-inch rim.

Features and dimensions

• Marked size and tread model: 10×2.75-6.5 / HP1007B.
• Construction: tubeless; use without an inner tube requires an airtight tubeless rim with a suitable valve.
• Tread: dense centre blocks, angled shoulder blocks, longitudinal and transverse channels.
• Approximate uninflated outer diameter: 247 mm.
• Approximate inner diameter and width shown: 163 mm inner diameter / 78 mm width.
• Approximate net weight shown: 900 g.
• Included: outer tire only; rim, valve and inner tube are not included.
• Model: Ausom L2 Max Dual Motor.

Compatibility

For Ausom L2 Max Dual Motor versions using 10×2.75-6.5 tires and a suitable 6.5-inch rim. Before ordering, compare the complete marking on the old tire and the rim sealing seat. The pictured HP1007B is approximately 78 mm wide: check clearance at the fork, brake and mudguard, as different tread designs of the same nominal size can have different actual widths.

When to replace and how to install

Replace the tire if the tread is worn or there are cracks, bulges or damage to the sealing bead. Release all air before removal; clean the rim and check the valve. Fit the new tire without damaging the bead, then check that it is seated evenly, holds air and allows free wheel rotation. Set pressure according to the vehicle instructions and the limits of both tire and rim.