Reinforced Brake Disc 160 mm with 6 Holes for Rovoron R7

Reinforced Brake Disc 160 mm with 6 Holes for Rovoron R7

This is a specific replacement brake disc designed for the Rovoron R7 electric scooter. It features a 160 mm diameter and a 6-hole mounting pattern. The reinforced design is intended to provide stable braking performance, particularly under heavier loads or during frequent braking.

This brake disc is suitable for replacing worn, warped, or damaged discs on your Rovoron R7. It is a crucial component for maintaining effective and safe braking on your scooter.

Key Features and Specifications

• Product Name: Reinforced Brake Disc 160 mm with 6 Holes for Rovoron R7
• Compatibility: Specifically designed for Rovoron R7 electric scooters.
• Diameter: 160 mm
• Mounting: 6-hole pattern (PCD 50mm, inner diameter 25mm).
• Design: Reinforced for enhanced durability and stable braking.
• Net Weight: 123g.
• SKU: ULP5118.00
• Package Includes: 1 brake disc and 6 mounting screws.

When to Replace Your Brake Disc

Consider replacing your brake disc if you experience any of the following:

• Pulsation, vibration, or rubbing sensations during braking.
• Visible damage, such as cracks, deep grooves, or severe discoloration from overheating.
• Uneven wear across the braking surface.
• The disc appears warped or bent.
• Damage to the mounting points or noticeable play in the disc.
• The disc thickness is below the manufacturer's recommended minimum limit (check your scooter's manual for specific values).

Important Compatibility Check Before Ordering

While this disc is specified for the Rovoron R7, it is essential to verify compatibility with your specific scooter model and year. Please compare the following details with your existing brake disc:

• Outer Diameter: Confirm it is 160 mm.
• Mounting Hole Pattern: Ensure your hub uses a 6-hole pattern. The images show a bolt circle diameter (PCD) of 50mm and an inner diameter of 25mm.
• Disc Thickness: While not explicitly stated, visually compare the thickness to your original disc.
• Disc Offset: Check if your current disc has any specific offset that might affect caliper alignment.

Variations in hub, caliper, or spacer designs can occur between different production batches or model years, even for the same scooter model. Matching these dimensions is crucial for correct fitment and safe operation.

Installation and Bedding-in Guidance

For optimal safety and performance, installation of brake components should ideally be performed by a qualified service technician. Ensure the following steps are taken:

• Cleanliness: Thoroughly clean the hub and caliper mounting surfaces before installation.
• Mounting Screws: Use the provided new mounting screws. Tighten them evenly and progressively to the manufacturer's specified torque values (refer to your scooter's service manual).
• Caliper Alignment: After installing the new disc, precisely center the brake caliper to ensure even pad contact and prevent premature wear.
• Brake Pads: Inspect your existing brake pads. Heavily worn, contaminated, or damaged pads should be replaced simultaneously to prevent damage to the new disc and ensure effective braking.
• Bedding-in Process: After installation, perform a gradual bedding-in process. This involves several light to moderate braking maneuvers from varying speeds, allowing the new disc and pads to conform to each other. Avoid hard, prolonged braking during this initial period.